When does start loads of white smoke. - glow plug switches on and off normally when preheating, but flashes for approx 60 seconds after starting. Understand this indicates a problem with the pre heat system. - can hear relay click on and off as it should. - voltage between battery + and bus bar is 12.5V with ignition on and does not seem to Hi Guys. Ran MultiECUScan(MES) and noticed a warning for Water in Fuel It is not a DTC however. Also, My dash warning light for Water in Fuel is not lit up. When I first saw this months ago , I did change the Fuel filter and cleaned the housing. The VAN runs and starts well. However, I Hi The engine speed sensor is located on the back of the engine (rear side) just under the turbocharger near the bell housing, it has a protective "bracket" held on by 2 x10mm bolts. If you crawl under the vehicle from the RHS you can see it, as I said just below the Turbo. #1 This is more for information. Been doing some testing of my coolant temp sensor. They are located near the thermostat housing. You need to remove heaps of pipes to see this properly. Here is a pic of the Temp sensor and Temp sender for those interested. The temp Sender is brown and this connects to the the dash temp gauge.
I believe it may have been an issue in one of the connector blocks that plugs in to ABS unit- dirty, corroded usual fiat guff that they are very prone to I should think. Still ok for now tho. I also believe that those 2 lights denote a fault with the front/rery electronic brake force distributor valve. My vehicle is a 3 axle motorgome BYW, also
5. Apr 19, 2014. #1. I have an Autotrail 630S on a 2001 Fiat Ducato 2.8JTD. The battery charging light is staying on. I have had the alternator tested and it has been verified as working. The alternator was removed and bench tested. It was replaced and all connections cleaned. The charging light is still on.
Fuse 13. Heater. Additional heater. 25.0 A. Fuse and relay location. Fuse box diagram. Cigarette lighter fuse. Assignment of the fuses and relay Fiat Ducato 1994-2002. HI All I have a peugeot boxer 2.8 2003 with a fiat 2.8JTD engine (apparently) It doesn't have glo plugs but a cold start unit. However this isn't functioning correctly. The engine fires up fine when the engine or ambient temp is warm, but when cold it just turns. Im looking for the wiring diagram so I can trace what happens and whats not working. Anyone help apparently my speedo sensor is the one with the nylon gear Location Sunshine Coast Qld, Aust. May 17, 2012 Technical fiat ducato 2.8 Jtd. wackiejack; The FIAT Ducato has an outside temperature sensor that can be found in the engine bay of Your vehicle. To find it, simply go to the front of Your car, and raise the hood. Inside the engine compartment, and beneath the area of the transmission and engine block itself, You will find the outside temperature sensor. If the sensor is bad, You can replace it for a cost between $24 and $85. Can anyone please help, had a fault now with camper for years, will run ok for a few miles, then total power loss and will just idle at tick over, will not rev, had turbo boost sensor changed, fuel reg, wastegate unit changes, seems underpowered as well
.
